The Lorex SG6130 2.4 GHz Wireless B/W 4-channel Camera with Receiver
System is a simple, reliable, and highly economical solution for most
basic remote monitoring needs. The easy-to install Lorex SG6130 camera
features wireless technology to save you the hassle of cable connections,
making it an ideal solution when portability is required. Not only is
this system compatible with all Lorex 2.4 GHz wireless devices, but with
built-in listen-in audio and the receiver's ability to autoscan up to
four separate cameras, this system can turn any TV into a video security
system that is great for monitoring situations where installing cables
are not convenient. The SG6130's camera utilizes a black-and-white CMOS (complimentary
metal-oxide semiconductor) image sensor with a 3.7-millimeter fixed
wide-angle lens. This unit delivers a resolution of 240 horizontal TVL
(TV lines), and has a minimum illumination of 0.1 Lux that is augmented
by six IR (infrared) emitting LEDs (light emitting diodes). The Lorex
SG6130 camera runs on 12-volt DC power via an included AC/DC adapter or
via eight 1.5-volt alkaline batteries, and has an operating temperature
of -10 to 50 degrees Celsius.
The SG6130's receiver allows for signal reception from up to 300-feet
away with a clear line of sight. The Lorex SG6130 receiver includes a
standard RCA composite video output connection that easily connects to
most TVs or VCRs, and runs on 9-volt DC power via an included AC/DC
adapter. This receiver can accept signals from up to four cameras
simultaneously, allowing you to autoscan all four or display full-screen
images of a single camera, and has an operating temperature of -10 to 50
degrees Celsius.
Technical Features:
- Signal distance: up to 300-feet (with clear line
of site) - Light sensitivity: minimum illumination of 0.1 Lux
- Horizontal
resolution: 240 TVL - Camera and receiver operating temperatures: -10 to
50 degrees Celsius - Camera dimensions: approximately 6 x 7 x 8
centimeters (W x D x H) - Receiver dimensions: approximately 16 x 9 x 4
centimeters (W x D x H)
Designed primarily for indoor use, the Lorex
SG6130 system deserves serious consideration as one of the easiest and
most economical monitoring solutions that anybody can set up anywhere.
This system can be installed and ready to go in under a minute, and the
camera's wireless capability lets you move your camera easily to another
area that needs monitoring. The SG6130 camera will run for up to 4-5
hours via battery power, while the SG6130 receiver's four-channel
capability allows you to expand your system as needed. Users should note
that the CMOS sensor may become permanently damaged if exposed to long
hours of direct sunlight or halogen light, so the camera should not be
mounted or pointed directly at the sun or other bright-light sources. About Surveillance Camera Technical Features
Lux rating is the
measurement used to indicate how sensitive a camera is to light, and
stands for the level of light reflected off a piece of paper by a candle
from one meter away. Thus a sensitivity of three Lux would mean a camera
could generate an acceptable picture of a piece-of-paper-sized object
that was illuminated by the equivalent of three candles from one meter
away. The lower the Lux level, the better the camera's ability to work
in low-light conditions. The camera's resolution should be greater than
or equal to the resolution supported by the system's recorder or monitor.
The S/N, or signal to noise ratio, is an important measure of a
camera's quality. A poor camera, low-light conditions or poor wiring
causes "noise" which consumes processing power and disk space. A camera
with a wide dynamic range is ideal, especially for recording areas in
which both indoor and outdoor light are present. CCD (charge-coupled
device) sensors provide high-quality images that are less susceptible to
noise. CMOS (complimentary metal-oxide semiconductor) sensors offer less
image quality, but are usually more cost-effective and energy efficient.
What's in the Box
Wireless camera, wireless receiver, AC Adapter
(camera), AC adapter (receiver), RCA A/V cable, RF cable, owner's
instructions, camera mount, battery box (camera), screws, and anchors
